Can-Am Spyder RT Series Instructions Manual page 19

rbl2014-004-044_a
1. Wiring connectors stored out of the way
2. LH adjuster cable, low beam headlight
3. RH adjuster cable, low beam headlight
26. Assisted by another person, position front
cargo module onto upper supports in front
frame of vehicle.
rbl2014-004-045_a
1. Front cargo module
2. LH upper support, RH similar
CE Models
27. Properly route adjuster cables for low beam
headlights along side frame members (both
sides).
PREDELIVERY
rbl2014-004-020_a
LH SIDE ILLUSTRATED, RH SIMILAR
1. Final adjuster knob location
2. Adjuster cable routing
3. Side frame member
All Models
28. Ensure air inlet duct in front cargo module is
properly connected to the primary air intake
silencer (LH side).
NOTICE Inlet duct must mate completely
around the outer diameter of the duct recepta-
cle on the primary air intake silencer.
In following illustration, some panels were
NOTE:
removed for clarity
rbl2014-004-016_a
LH SIDE VIEW
1. Air inlet duct
2. Primary air intake silencer
3. Air inlet duct connection
29. Ensure no wiring was pinched between cargo
module and frame prior to installing any fas-
tener.
30. Properly position air inlet duct with alignment
key and tighten hose clamp on air inlet duct as
specified.
2014-1
PARTS TO BE INSTALLED
19 / 52