Lights - Can-Am Spyder RT Series Instructions Manual

Lights

Headlights Aiming Verification
North American Models
1. Set the rear suspension air pressure to 0 kPa
(0 PSI) using the manual ACS inflation valve lo-
cated under the seat.
rmo2010-001-056_a
1. Manual ACS inflation valve
2. Position the vehicle in front of a test surface as
shown.
rmo2010-001-007_b
A. 10 m (33 ft)
90°
rmo2010-001-008_a
3. Trace 2 lines parallel to the ground on the test
surface as follows:
PREDELIVERY
LINES ON THE TEST SURFACE
Line A 642 mm (25.3 in) above ground
Line B 732 mm (28.8 in) above ground
4. Select low beam.
5. Beam aiming is correct when the focus point
(brightest spot) of the headlight reflection is
within the marks.
rmo2010-001-302_b
TYPICAL HEADLIGHT REFLECTION ON TEST SURFACE
1. Ground
2. Focus point
A. 642 mm (25.3 in) above ground
B. 732 mm (28.8 in) above ground
CE Models (Low Beam)
This verification is valid for either left-hand
NOTE:
or right-hand traffic regulations.
1. Set the rear suspension air pressure to 0 kPa
(0 PSI) using the manual ACS inflation valve lo-
cated under the seat.
rmo2010-001-056_a
1. Manual ACS inflation valve
2. Position the vehicle in front of a test surface as
shown.
2014-1
SETUP
2
1 A B
43 / 52