Can-Am Spyder RT Series Instructions Manual page 31

4. Remove outer panel from LH and RH rear stor-
age covers.
rbl2014-004-061_a
LEFT REAR STORAGE COVER ILLUSTRATED, RIGHT SIDE
SIMILAR
Rear Signal Lights Installation
1. Using a small portable hand torch, apply a light
flame treatment to the areas identified in fol-
lowing 2 illustrations.
The light flame treatment is only required
NOTE:
to burn off impurities on the panel surface in
preparation of 4 locking tie mount installations.
NOTICE When applying flame treatment, be
very careful to not overheat panel or damage
will occur.
WARNING
Be extra careful when working with an open
flame. Ensure there are no flammable mate-
rials or vapors in the immediate area to pre-
vent the possibility of a fire or an explosion
occurring.
PREDELIVERY
rbl2014-004-065_a
LH SIDE ILLUSTRATED, RH SIDE SIMILAR
1. Inner storage compartment cover
2. Pass through hole, signal light wire, aft corner
3. Apply flame treatment here
In the following illustration, the rear fender
NOTE:
panel is not shown for clarity of illustration. To ap-
ply flame treatment, it will be necessary to gently
pull open the side of the rear fender panel.
rbl2014-004-067_a
REAR VIEW OF VEHICLE, REAR FENDER PANEL NOT SHOWN
1. Apply a light flame treatment here
2. LH storage compartment
3. RH storage compartment
2. Install turn signal light on outer left side storage
cover as per following illustration. Pay attention
to retaining washer position. Ensure light lens
is facing aft.
NOTICE Do not exceed specified tightening
torque or damage to the light assembly may
occur.
2014-1
PARTS TO BE INSTALLED
31 / 52