Installing In A Chassis - D-Link DMC-810SC Quick Installation Manual

Switch
There is a two pin DIP switch on the module which define as switch
1 and switch 2:
Switch 1: Fiber mode switch

When the switch was turned to "On", it means that the fiber was
turned to forced mode, and "Off" for auto-negotiation mode.
Note: Be sure the opposite end is using the same setting (forced or
Auto-negotiation). And when using two converters at the same time,
the two converters MUST set to forced mode.
Switch 2: LLR

When the switch was turned to "On", it means that the LLR was
enabled and "Off" for disabled.
Note: When using two converters at the same time, then only one
converter need to enable the LLR function.
I
NSTALLING IN A
The Converter can be fit into any of the expansion slots on DMC-1001
chassis.
First, install the converter onto a carrier supplied with the chassis:
Unscrew and pull out the media converter board
Step 1. Unscrew the carrier from the desired expansion slot on the
chassis.
C
HASSIS
5