About This Document; General Safety Precautions - STEINEL L 220 S Information

GB

1. About this document

Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or
in part only with our consent.
– Subject to change in the interest of technical
progress.
Symbols
!
Hazard warning!
Reference to other information in the
...
document.

2. General safety precautions

Disconnect the power supply before
!
attempting any work on the unit.
• During installation, the electric power cable to be
connected must not be live. Therefore, switch off
the power first and use a voltage tester to make
sure the wiring is off-circuit.
• Installing these lights involves work on the mains
voltage supply; installation must therefore be
carried out professionally in accordance with
the applicable national wiring regulations and
electrical operating conditions (DE-VDE 0100,
AT-ÖVE/ÖNORM E 8001-1, CH-SEV 1000).
• Only use genuine replacement parts.
• Repairs may only be made by specialist work-
shops.
3. L 240 S / L 220 S
L 220
Proper use
– Outdoor light with LEDs as the light source.
– Suitable for wall mounting outdoors.
– The unit is not suitable for connecting to a dimmer.
Not dimmable
– These sensor versions (S versions) also feature
an infrared sensor for detecting movement.
Operating principle
– Outdoor lights
– LED technology
The S versions also provide these functions:
– The integrated infrared sensor detects the heat
radiated from moving objects (e.g. people,
animals).
– The heat detected in this way is converted elec-
tronically into a signal that switches the LED light
ON automatically.
– The most reliable way of detecting motion is to
install the unit with the sensor aimed across the
direction in which a person would walk.
– Reach is restricted when the unit is approached
head on.
– Obstacles (e.g. trees, walls etc.) interrupt the line
of sensor vision.
– Heat radiation is not detected through obstacles
(e.g. walls or panes of glass), the sensor is not
triggered.
– Sudden fluctuations in temperature as a result of
changes in weather are not distinguished from
sources of heat.
L 240 S package contents (Fig. 3.1)
L 220 S package contents (Fig. 3.2)
L 220 package contents (Fig. 3.3)
L 240 S product dimensions (Fig. 3.4)
L 220 S product dimensions (Fig. 3.5)
L 220 product dimensions (Fig. 3.6)
L 240 S product components (Fig. 3.7)
L 220 S product components (Fig. 3.8)
L 220 product components (Fig. 3.9)
A Light enclosure with base
B Plug-in terminal
C Wall mount
D Sensor (S only)
Luminous intensity distribution (Fig. 3.10)
4. Installation
• Switch OFF power supply (Fig. 4.1)
The leads consist of three wires:
L = phase conductor (usually black,
brown or grey)
N = neutral conductor (usually blue)
PE = protective-earth conductor (green/yellow)
If you are in any doubt, identify the conductors
using a voltage tester; then disconnect from the
power supply again. Connect the phase conductor
(L) and neutral conductor (N) to the terminal block.
– 12 –