eIVP-CFS-IV-V0004
3.2 Main Board Jumper Settings
3.2.1 Board top view of the system main board with jumper and deep switch
The figure above is the top view of the system main board. It shows the location of the jumpers
and the switches.
You may configure your card to match the needs of your application by setting jumpers. A
jumper is a metal bridge used to close an electric circuit. It consists of two metal pins and a
small metal clip (often protected by a plastic cover) that slides over the pins to connect them.
To "close" a jumper, you connect the pins with the clip. To "open" a jumper, you remove the
clip. Sometimes a jumper will have three pins, labeled 1, 2 and 3. In this case you would
connect either pins 1and 2, or 2 and 3.
You may configure your card to match the needs of your application by DIP switch. As below
show the deep switch on and off.
32