ElectrIQ eiQCHINTGY60 User Manual page 8

6. Install the air outlet onto the hood by aligning the 3 slide slots of the outlet with the
three edges on the fan housing, and sliding the outlet into position.
7. Connect the air-outlet board and the vent hose and route it appropriately. Rigid kits, if
preferred, can be obtained from either the retailer who supplied the hood, DIY Stores or
Builders Merchants., DIY Stores or Builders Merchants.
DOOR INSTALLATION
1. The door should be no less than 16mm thick, 385-700mm high, and weigh no more
than 7KG. Pull out the movable fan-shaped frames by the plastic handle, and place
the fan-shaped frames on each side.
8