(3) Head selection (Memory switch No. P70)
A
B
3) Press
❼ to flash the set value (B) on and off. In this state, select the corresponding type
ofmachine head by pressing
Set value = 2: DDL8000APMS
Set value = 3: DDL8000APSH
4) Data is initialized by pressing
(Cautions) This item has been factory-adjusted at the time of shipment. Carry out the machine
head setting procedurein the case the control box is replaced, or in any case where it is
necessary.
(4) Adjusting the main shaft stop position (Memory switch No. P72)
A
❻
❼
⓬
❽
❻ .
❽ . Then, the sewing machine returns to the normal sewing state.
❻
❼
⓬
❽
1) Activate the memory switch in the user level.
(Refer to "4.-(2)-[1] User level".)
2) Press
setting No. A blink, and press
select "P70".
1)
Activate the memory switch in the service level.
(Refer to "4.-(2)-[2] Service level".)
2)
Press
No. A on and off. In this state, press
❻ to select parameter "P72".
3)
Turn handwheel ❶ in the normal direction of
rotation to align marker line on the electrical
box cover with marker line on the handwheel.
4)
Press
❽ to determine the setting.
5)
Press
⓬ to return the sewing machine to
the sewing state.
(Important) If the engraved line (blue9 of the
hand wheel is largely displaced
from the engraved line (blue) of
the cover after thread trimming,
adjust the angle of the head by the
operations below.
(Caution) This item was adjusted at the time of
shipment.
– 84 –
❼ to make the pressing function
❼ to flash function setting
❻ to