Table of Contents
Advertisement
Light contact
⓬
❽
⓫
⓮
❽
⓫
that condensation arm ❽ comes in contact with the feed adjusting rod and condensation arm ❽ without
a gap. If condensation arm ❽ comes in contact with the feed adjusting rod but there is a gap between
the arm and condensation stopper ⓫ , the condensation pitch will be decreased. If, on the other hand,
condensation arm ❽ comes in contact with the condensation stopper ⓫ but there is a gap between
the arm and feed adjusting rod, the condensation pitch will be increased. In either case, carry out the
adjustment again.
3) Keeping the state as described in 2), turn conden-
(Caution) Take care not to allow condensation
4) 3Keeping the state as described in 3), tighten
Feed adjusting rod
5） After tightening the setscrew, check to make sure
– 131 –
sation stopper shaft ⓬ until condensation
stopper ⓫ comes in light contact with conden-
sation arm ❽ .
arm ❽ to move when condensation
stopper ⓫ comes in light contact with
condensation arm ❽ . If condensation
a r m ❽ m o v e s , t h e c o n d e n s a t i o n
pitch cannot be adjusted as desired,
resulting in thread trimming failure or
in longer remaining length of thread
after thread trimming.
setscrew ⓮ .
[Tightening torque: 4.8 - 5.8 N·m (50 - 60 kgf·cm)]
Advertisement
Table of Contents
