Table of Contents
Advertisement
④ Installing the condensation arm
⑤ Installing the feed adjustment pin
1) Reversing the removal procedure, install the feed adjustment pin.
2) Carry out adjustment of the forward / reverse feed alignment, etc. where appropriate.
3) Apply JUKI Grease A to the sliding surfaces.
⑥ Setting up the condensation plunger
Solenoid plunger
Ａ
Ａ
Ａ
⓰
❽
❿
1) Apply JUKI Grease A to the sliding surfaces A of
condensation arm ❽ and hinge screw ❿ , and the
contact surfaces of the spring and condensation
arm ❽ .
2) S ecure condensation arm ❽ to w hi c h the
condensation arm return spring is attached, with
hinge screw ❿ .
[Tightening torque: 7.8 - 8.8 N·m (80 - 90 kgf·cm)]
3) Put one end of the condensation return spring on
condensation arm stopper ⓰ .
1) Apply JUKI Grease A to the sliding surfaces of
condensation arm ❽ and hinge screw ❿ , and the
contact surfaces of the spring and condensation
arm ❽ .
2) Place the solenoid plunger in the forked section
of condensation arm ❽ .
(Caution) Turn the notched side of the solenoid
plunger upward. If the solenoid plunger
is attached in the wrong orientation,
the condensation stitch device will not
move.
Up
– 129 –
Advertisement
Table of Contents
