Image Quality Settings; Set Image - HikRobot ID6000 Series User Manual

Camera Mode
Test Mode
Normal Mode
Raw Mode
Note
Before specific camera settings, you need to set camera mode as Normal. Otherwise, the camera
parameters may be different.

7.3 Image Quality Settings

This section introduces how to set image related parameters of the camera via client software.
Note
For different models of the camera, the specific parameters may differ, and the actual device you
purchased shall prevail.

7.3.1 Set Image

You can set different image parameters like exposure time, gain, Gamma, acquisition frame rate,
acquisition burst frame count in image parameters interface.
Note
● Make sure you have select the camera to be set in Device Connection before setting image
parameters.
ID6000 Series Smart Code Reader User Manual
Figure 7-1 Select Camera Modes
Table 7-1 Description
It is used during camera debugging. The camera outputs images that are
acquired in real-time, and displays barcode information.
It is used during camera normal operation. After reading barcode in image,
the camera outputs image and barcode information.
It is used during testing image data. The camera outputs raw data and
displays barcode information.
Description
22