HikRobot ID6000 Series User Manual page 51

Select Frame Burst Stop Active
Note
The Frame Burst Stop Active is not supported when the trigger polarity is level high or level low.
If the burst of a frame stops, the output signal will be triggered. When you select Frame Burst Stop
Active as Line Out Activation Event, you can set its output delay time and duration.
Line Out Delay Time
It sets the delay time for outputting the output signal.
Line Out Duration
It sets the time duration of the output signal.
ID6000 Series Smart Code Reader User Manual
Figure 7-29 Select Frame Burst Start Active
Figure 7-30 Select Frame Burst Stop Active
42