Raider RD-ECS22 User Manual page 25

When trimming tree branches, always cut downward to enable free fall of cut branch.
However, sometimes undercutting the branch from the bottom may be helpful.
Be very careful when cutting a branch that may be under stress. Such branch may spring
aside and hit the operator.
Do not cut branches when climbing up the tree. Do not stand on ladder, platforms, logs or
positions that may cause loss of balance and control over the chain saw. Do not cut above level
of your shoulders. Always hold the chain saw with both hands.
4.19. Safe work with chain saw.
Never use the chain saw during rain and in moisture. Whenever the extension cord is
damaged, remove its plug from mains socket immediately. Never use damaged power cord.
All parts should be assembled properly and fulfill requirements that ensure safe chain saw
operation. Any damaged protective part should be repaired or replaced immediately.
5. Operation and maintenance.
Unplug the power cord from the mains socket before commencing any activities related to
installation, adjustment, repair or maintenance.
5.1. Storage.
Pay special attention to keep the ventilation holes of the engine casing pervious.
Clean plastic parts with mild detergent and a sponge.
You can proceed with maintenance actions only described within this instruction manual.
Any other action can be carried out only by authorized service.
Do not make any changes in chain saw construction.
When not in use, chain saw should be stored clean, on flat surface, in dry place and beyond
reach of children.
5.2. Guide bar and saw chain.
Check condition of the guide bar and chain every 5 hours of the saw operation.
Loosen and unscrew the guide bar fixing nut (12).
Remove the casing and disassemble guide bar (9) and chain (8).
Clean oil holes and groove in the guide bar (9).
Lubricate tip chain wheel of the guide bar (10) through the hole located on the guide bar tip.
Check condition of the chain (8).
5.3. Chain sharpening.
Pay attention to cutting tools. Cutting tools should be sharp and clean, it allows efficient and
safe operation. Operating the saw with blunt chain causes quick wear of the chain, guide bar
and driving chain wheel, and breaking the chain in the worst case. That is why it is important
to sharpen the chain on time.
Chain sharpening is a complex operation. Sharpening the chain by yourself requires use
of special tools and skills. It is recommended to entrust sharpening the chain to qualified
persons.
All faults should be repaired by service workshop authorized by the RAIDER.
6. Environmental protection.
Never place any electric tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and
electronic equipment and its implementation in national laws, old electric tools
have to be separated from other waste and disposed of in an environment-friendly
fashion, e.g. by taking to a recycling depot.
Recycling alternative to the demand to return electrical devices:
As an alternative to returning the electrical device, the owner is obliged to cooperate in
ensuring that the device is properly recycled if ownership is relinquished. This can also be
done by handing over the used device to a returns center, which will dispose of it in accordance
with national commercial and industrial waste management legislation. This does not apply to
the accessories and auxiliary equipment without any electrical components which are included
with the used device.
25