Table of Contents
Advertisement
3.4.4
NETWORK
3.4.4.1
Network set
Read the description under the following figures for this menu page:
After having selected the network mode (DHCP, PPPOE or static allocation) and set the ports, the remote NVR can be
accessed via a network or the Internet.
The main functions of the Network OSD Menu are:
UPnP (Universal Plug and Play) function: if the router supports the UPnP function and <UPnP> is set to "On",
•
the system will automatically send the port to the router.
DNS function: the DNS server is generally supplied by the local ISP. Enter the IP address of your DNS here.
•
Note: The server port may not duplicate the port set on the network.
The NVR can be reached on the Internet (with or without DDNS) only if the access provider assigns a public IP address
(either static or dynamic) to the router. It is therefore advisable to previously verify this essential detail with the Internet
access provider.
1.
NVR network parameter setup
The Urmet NVR network configuration is in DHCP mode by default (automatic IP address allocation):
If the network to which NVR is connected supports DHCP, simply display the parameters that the NVR
a)
acquires automatically from the network in "Menu
parameters to be allocated and appear automatically in the menu: IP address, subnet mask, gateway and
DNS (see below).
Press [Save] to save the changes.
The NVR parameters must be allocated manually if the network does not support DHCP. Select "Type =
b)
Static" in "Menu
and DNS.
DS1098-019A
Parameter
Network" and fill in the following fields: IP address, Subnet mask, Gateway
26
Network". Wait for approximately ten seconds for the
Advertisement
Table of Contents
