Table of Contents
Advertisement
Connect the following to the I/O panel on the projector:
♦
Video player through the S-video connector.
♦
Computer through the M1-A connector
Perform the following tests
Test
Power Up
Connect AC power, and turn
the unit on.
Cosmetics and mechanicals
Adjust the projector so that the
image is square. Make sure
the lens is at a 90° angle to
the wall.
Video source
On the keypad, press the
Video button display the S-
video source.
Audio from video source
Software Version / Keystone
/ Reset All
1. Press and hold the
Keystone up and
Keystone down
button on the keypad.
2. Press the Menu
button, and then
navigate to About.
3. Navigate to Main >
Settings > Service.
Select Factory Reset.
TDP-P6 Service Manual
Verification
Verify that the proper splash (logo) screen appears. If the incorrect logo
screen appears, you must install the proper brand system software. The
logo screen is automatically installed when you do this.
Verify image quality.
Verify that the elevator and leveling foot are functional.
Verify that the focus and zoom rings operate properly.
Verify cosmetics.
Verify that the video automatically synchronizes. If it doesn't, press the
Video button on the keypad.
Verify there is no distortion, noise or other abnormalities.
Verify that the audio plays clearly.
Verify that the audio is clear with no distortion.
Verify that the keystone adjustment works properly.
Verify software version in the About box.
Verify the keys are not sticky.
67
Advertisement
Table of Contents
