4
Remove the two M2.5x4 Torx screws that fasten the engine to the bottom enclosure and power
supply.
5
Lift the engine out of the bottom enclosure.
6
If you are replacing the engine with a new one, do the following:
1. Remove the dampening gasket on the end of the formatter ECA as shown below. You
will install the gasket on the new engine. If the gasket is missing or damaged, a new one
is available in the Hardware Kit (802-0036-xx).
2. Place the old engine in the plastic clamshell in which the new engine was packaged.
TDP-P6 Service Manual
52