♦
Plug in the color wheel power cable. See step 6 in the disassembly procedure.
♦
Align the controller/power supply and controller/engine connectors. Ensure that the color wheel is
centered in the cutout on the controller. Then press the controller firmly as shown below to fully
engage the connectors.
♦
Fasten the controller to the optical engine with the three M2.5x4 screws. Torque the screws to 3 in./lb.
(.329 Nm).
♦
Plug in the speaker and color wheel cables. See step 3 of the disassembly procedure.
TDP-P6 Service Manual
50