Table of Contents
Advertisement
3
Insert a small bladed screwdriver into the pry point and lift the lamp door off of the projector.
4
To remove the lamp, do the following:
1. Disconnect the lamp power connector from its plug in the projector. To do this, press
down on the latch on the top of the connector, while pulling the connector out of the plug.
2. Lift the handle on the lamp to release the latch that holds the lamp in place. Then lift the
latch off the tab inside the projector.
3. To remove the lamp, lift the handle upward and slightly back to disengage the alignment
tab and fan ducting. If necessary, gently press down on the fan ducting.
TDP-P6 Service Manual
26
Advertisement
Table of Contents
