Table of Contents
Advertisement
LED flashes repeated red single-flash sequence
LCD Message
LAMP WON'T STRIKE
RETRYING WAIT...
Repeats
Replace power
supply
(page 54)
TDP-P6 Service Manual
The lamp won't strike after five attempts. The status
LED flashes a
repeated red single-flash
Replace the lamp module
(page 25)
Ensure that the lamp sync cable
(page 35) is connected to the
controller ECA and the ballast.
Voltages
good at power
No
supply/controller
connector?
(page 16)
Verify the repair by
restarting the Power
Diagnosis process
(page 7)
sequence.
Replace the
Yes
ballast
(page 38)
Solve the
Yes
problem?
Replace controller ECA
(page 43)
No
10
Advertisement
Table of Contents
