Toshiba TDP-P6 Manual page 41

Hide thumbs Also See for TDP-P6:

Table of Contents

Assembly Notes

♦

Make sure the rubber feet are attached to the bottom of the blower assembly before you install it. The

feet have +-shaped slots that mate with the +-shaped tabs on the bottom of the blower.

♦

Place the blower assembly upside down on the controller ECA, then plug the blower power cable into

its connector. See step 2 above.

1. Rotate the blower as you lower it into the bottom enclosure, making sure that the

following surfaces mate properly:

2. The feet fit into the matching round guides in the bottom enclosure

3. The portion of the ECA above the blower power cable connector fits beneath the

controller ECA. Note that there is a dampening pad that fits between the two ECAs. This

pad must be in place. If it is missing, order the hardware kit (802-0036-xx).

TDP-P6 Service Manual

Table of Contents