Table of Contents
Advertisement
Assembly Notes
♦
To install the lamp, first align the tab on the bottom of the lens end of the lamp with the slot inside the
projector. Then align the duct on the rear of the lamp with the duct inside the projector. Press the
lamp into place.
♦
Place the latch over the tab in the projector. Make sure that the latch fully engages the tab. Then
press the handle down to lock the lamp in place.
♦
To install the lamp door, insert the two tabs on the door into the matching slots near the front of the
projector. Swing the lamp door shut, pressing it into place so that the lamp connector on the door
engages. Tighten the captive screws to 3 in./lbs. (.329 Nm).
♦
If you installed a new lamp door, affix a new certification label to the door.
♦
If you installed a new lamp, reset the lamp timer. To do this, press and hold the Volume + and
Volume - keys for 10 seconds. After you reset the lamp timer, read the timer value to make sure it
was reset. Navigate to the About screen from the Main Menu, then view the Lamp Hour value. It
should show 0 hours.
TDP-P6 Service Manual
27
Advertisement
Table of Contents
