Commodore AMIGA Technical Manual page 9

AMIGA 1000 ASSEMBLY LEVEL REPAIR
NOTE: WRITE-PROTECT ALL VOLUME DISKS
BEFORE BEGINNING!
• Slide the write-protect tab up toward the edge
of the disk to expose the small hole in the disk
case.
1 .6 SYSTEM DRIVE TEST
1.6.1 Insert the diskette labeled KICKSTART into the internal drive.
At this time, the screen should turn white as the system loads the disk. The drive activity
light will flash briefly and the drive access sounds should be heard. After approximately 30
seconds and some screen changes, the system should display a hand holding a diskette
labeled WORKBENCH.
• If the hand holding the diskette labeled KICKSTART REAPPEARS, re-seat the diskette and
RETRY. If after 3 or 4 retries, the system still does not accept the KICKSTART diskette, try
a DIFFERENT COPY of the disk.
• If the disk still WILL NOT LOAD, continue to 1.7 DRIVE ASSEMBLY CHECK.
1 .6 .2 Remove the KICKSTART disk.
1 .6 .3 Insert the diskette labeled WORKBENCH into the internal drive.
At this time, the screen will turn white for approximately 2 seconds and then display the
boot-up message while continuing to load from the disk.
• If the hand holding the diskette labeled WORKBENCH REAPPEARS, re-seat the diskette and
RETRY. If after 3 or 4 retries, the system still does not accept the WORKBENCH diskette,
try a DIFFERENT copy of the disk.
• If the disk STILL WILL NOT LOAD, continue to 1.7 DRIVE ASSEMBLY CHECK.
When loading is complete, the screen will be blue with the WORKBENCH DISK ICON in the
upper right hand corner. The TITLE BAR message will be:
Amiga Workbench Version 1.0 167840 free memory
1 .6 .4 Select the WORKBENCH ICON with the mouse.
With the mouse, move the pointer on to the ICON and click the left button once. The ICON
will turn black to indicate it has been selected.
1 .6 .5 Select DUPLICATE from the menu.
Press and hold the right mouse button while sliding the pointer to the upper left corner of
the title bar. When the pointer is over the word Workbench, the word will highlight and the
menu selection will be displayed.
Continue to depress the right mouse button and slide the pointer down to the word
DUPLICATE and, when DUPLICATE is highlighted, release the right mouse button.
The DISKCOPY W INDOW will be displayed and will continue to prompt you through the en­
tire DISKCOPY procedure.
1-6