Commodore AMIGA Technical Manual page 22

AM IGA 1000 ASSEMBLY LEVEL REPAIR
2 .4 REM OVING THE TOP RFI SHIELD
2.4.1 As shown in Fig. 2-7, remove the following
screws:
QTY LOCATION
8 EACH SIDE OF REAR CONNECTORS
3 ALONG TOP OF POWER SUPPLY ASSY
1 FLUSH MOUNTED TOP REAR OF DRIVE
2 AT FRONT OF PCB
2 .4 .2 Untwist the 2 shield tabs at the right side towards
the rear and the rear left corner.
2 .4 .3 Gently work shield loose from the PCB assembly. Fig. 2-8. LED Harness Removal
2 .4 .4 At this time, the LED harnesses connected to the
front BEZEL can be unplugged. The drive LED wire discon­
nects at an in-line connector and the power LED discon­
nects at the PCB, J 1 5 as shown in Fig. 2-8. Set the front
BEZEL aside.
2-3