Commodore AMIGA Technical Manual page 25

AMIGA 1000 ASSEMBLY LEVEL REPAIR
SECTION 3. AMIGA ASSEMBLY
3.1 POWER SUPPLY INSTALLATION
3 .1.1 To install the power supply into the bottom case,
insert the assembly on an angle to engage the slots in the
bottom case. See Fig. 3-1.
3 .1 .2 Check that the power supply assembly is installed
properly before continuing to the next step.
Fig. 3-1. Power Supply Insertion
3 .2 PCB INSTALLATION
3 .2 .1 Install the LOWER RFI SHIELD on the bottom of
the PCB and twist the 8 tabs at locations A 1 , A4, A9, A 10,
T9, T3, N 1, J 1 .
3 .2 .2 Gently insert the PCB into the bottom case. To
clear the mouse connector cut-outs, you will have to in­
sert the board on an angle while gently holding the right-
side bottom housing out. See Fig. 3-2. The rear panel hous­
ing must be inserted along with the PCB. While holding it
in place over the rear connectors, slide it into its tracks,
as shown in Fig. 3-3.
3 .2 .3 Install the 4 PCB screws at locations A 1, A6, T 1 ,
T4. Note that the power supply screws are larger than the
other two.
3 .2 .4 Connect the power supply cable at location G7.
Fig. 3-2. Clearing the Right Side
Connectors
Fig. 3-3. Rear Housing Insertion
3-1