Commodore AMIGA Technical Manual page 26

AMIGA 1000 ASSEMBLY LEVEL REPAIR
3 .3 DRIVE INSTALLATION
3 .3 .1 Position the drive over the PCB and re-connect
the ground wire at T4. See Fig. 3-4.
3 .3 .2 Install the 4 screws in the sides of the drive
bracket at locations T2, T4, L2, L4. See Fig. 3-5.
Fig. 3-4. Drive Cable Locations
3 .3 .3 Install the 4 brass stand-offs located at the con­
nectors J10 and J11 at board locations T1, T2, T3, T4.
See Fig. 3-6.
3 .3 .4 Connect the following cables:
CABLE LOCATION
Fig. 3-5. Drive Screw Locations
LOGIC RIBBON R8
POWER H7
Note that the ribbon cable is mounted with the
ribbon coming out of the connector towards the front of
the computer.
3 .3 .5 Replace the plastic tie-wrap that holds the LED
cable at location T 1 . The cable must be secured to be cer­
tain that it will not interfere with drive operation.
Fig. 3-6. Stand-off Locations
3-2