Table of Contents
Advertisement
NOTICE! Danger from improper handling!
Product can be damaged!
▶ Do not install the coupling hub on the drive shaft of the axial piston unit by
striking it.
1� Install the specified coupling half on the drive shaft of the axial piston unit
according to the instructions of the coupling manufacturer.
The drive shaft of the axial piston unit is equipped with a female thread.
Use this female thread to pull the coupling element onto the drive shaft. The
size of the female thread can be seen in the installation drawing.
2� Make sure that the installation location is clean and free from dirt and foreign
particles.
3� Clamp the coupling hub onto the drive shaft or ensure permanent lubrication
of the drive shaft. This prevents the formation of frictional corrosion and the
associated wear.
4� Transport the axial piston unit to the installation location.
5� Install the coupling on the output shaft of the drive motor in accordance with
the specifications provided by the coupling manufacturer.
Do not fasten down the axial piston unit until the coupling has been
correctly installed.
6� Fasten the axial piston unit at the installation location.
7� Align the drive shaft of the axial piston unit and the drive shaft of the machine
so that there is no angular deviation.
Make sure no excessive axial and radial forces are acting on the drive shaft.
8� Details on the required tools and tightening torques for the mounting bolts are
available from the machine/system manufacturer.
7�5�5 Remove the spacer (for version with through drive)
Abb� 24: Removing the spacer
Axial piston units with through drive are delivered with a spacer (1). The spacer is
designed for transport protection and to reduce the hub's axial clearance (2).
Installation | A10FZO/G, A10VZO/G
1
3
2
RE 91485-01-B/2021-11-18, Bosch Rexroth AG
43/72
Advertisement
Table of Contents
