Table of Contents
Advertisement
Transporting with eye bolt
Size
10
Width
mm
Dimensions vary by equipment. The values applicable for
your axial piston unit can be found in the installation drawing
Height
mm
(request if necessary).
Depth
mm
Weight may vary by equipment.
6�1�1 Transport by hand
Up to a specific maximum weight, axial piston units can be transported by hand
for a short distance. Observe the national regulations in your country. To prevent
health damage, we recommend renouncing any transport by hand.
CAUTION! Risk of injury due to heavy loads!
Health hazard from carrying axial piston units.
▶ Only manually transport the axial piston unit for a short period of time.
Observe the national regulations in your country for manual transport.
▶ Always use appropriate lifting, lowering and moving techniques.
▶ Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Do not transport the axial piston unit by sensitive assembled parts
(e.g. sensors or valves).
▶ Carefully place the axial piston unit on the seating to prevent it from being
damaged.
6�1�2 Transport with lifting devices
For transporting, the axial piston unit can be connected to a lifting device via an
eye bolt or a lifting strap.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶ For all female threads, use a stud end from the same system of units and of the
correct size.
▶ To do this, screw an eye bolt completely into the female thread on the drive
shaft. The thread size is indicated in the installation drawing.
▶ Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20%.
You can lift the axial piston unit as shown in Abb. 10 with the eye bolt screwed
into the drive shaft.
Transport and storage | A10FZO/G, A10VZO/G
18
RE 91485-01-B/2021-11-18, Bosch Rexroth AG
28
63
27/72
Advertisement
Table of Contents
