Table of Contents
Advertisement
Risk of confusion with
threaded connections
Axial piston units are used in application areas that use the metric system as well
as the Anglo-American (imperial) and the Japanese measuring system
(JIS – Japan Industrial Standard). Various kinds of seals are also used.
The system of units, the kind of seal and the size of female thread and stud ends
(e.g. threaded plug) must all match.
There is a risk of confusion due to the limited ways of visually telling them apart.
WARNING! Leaky and bursting stud ends!
For fittings, if a stud end that does not match the system of units, kind of seal and
size of the female thread is pressurized, the stud end may loosen itself or even be
ejected from the hole in a projectile-like manner. This can result in serious injury
and property damage. Hydraulic fluid can escape from this leakage point.
▶ Use the drawings (installation drawing) to determine the required stud end for
each fitting.
▶ Make sure the right fittings, mounting bolts and threaded plugs are installed.
▶ For all female threads, use a stud end from the same system of units and of the
correct size.
Installation | A10FZO/G, A10VZO/G
RE 91485-01-B/2021-11-18, Bosch Rexroth AG
47/72
Advertisement
Table of Contents
