Table of Contents
Advertisement
7. To switch to black, press and release the CANCEL key.
The display will now show:
8. Take up to six measurements over the black substrate (use the same
procedure as when measuring over white).
If necessary, it is possible to switch between black and white
measurements at any time (by pressing the CANCEL button to change) and make up to six
measurements on each part of the sample.
When all the black and white measurements have been made, the calculation of opacity can be
initiated by combining the measurements.
9. To combine the measurements, press and hold the CANCEL key for
three seconds. The display will now show:
10. Press the READ key to confirm opacity calculation.
The gauge will now calculate the opacity and the result will be shown
on the display.
BLACK
Value
45/0
0
Black/White-Batch
45/0
69.7
ARE YOU SURE ?
Press Read Key
Batch
H.Power
3
94.5%
R
No.
0
4
11
Advertisement
Table of Contents
