Steps
1. Align and place the antenna modules in the slots on the middle frame.
2. Adhere the copper foil that secures the antenna cables to the middle frame.
3. Replace the two screws (M2x2.5) to secure the antenna modules to the middle frame.
4. Route the antenna cables through the routing guides on the display-assembly base.
Next steps
1. Install the speakers.
2. Install the
rear-I/O
bracket.
3. Install the
system
board.
4. Install the
bottom
cover.
5. Install the
wireless
card.
6. Install the hard-drive.
7. Install the
system-board
8. Install the
back
cover.
9. Install the
cable cover
10. Install the stand.
11. Follow the procedure in
Display panel
Removing the display panel
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
cable cover
4. Remove the
back
cover.
5. Remove the
system-board
6. Remove the
hard
drive.
7. Remove the
bottom
cover.
8. Remove the
rear-I/O
9. Remove the speakers.
10. Remove the
camera
assembly.
11. Remove the
system
board.
About this task
The following image indicates the location of display panel and provides a visual representation of the removal procedure.
shield.
(optional).
After working inside your
Before working inside your
(optional).
shield.
bracket.
computer.
computer.
Removing and installing components
71