Rear-I/O Bracket; Removing The Rear-I/O Bracket - Dell OptiPlex 3280 Service Manual

CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor
cover.
Next steps
1. Install the heat sink.
2. Install the system fan.
3. Install the system-board
4. Install the back cover
5. Install the cable cover
6. Install the stand.
7. Follow the procedure in

Rear-I/O bracket

Removing the rear-I/O bracket

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the cable cover
4. Remove the back cover.
5. Remove the system-board
6. Remove the bottom cover
About this task
The following image indicates the location of the rear-I/O bracket and provides a visual representation of the removal
procedure.
shield.
(optional).
After working inside your
Before working inside your
(optional).
shield.
computer.
computer.
Removing and installing components 49