Installing the hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard drive and provides a visual representation of the installation procedure.
Steps
1. Slide the hard-drive assembly into the slot on the display-assembly base.
2. Replace the two screws (M3x5) that secures the hard-drive assembly to the display-assembly base.
Next steps
1. Install the
cable cover
2. Install the
back
cover.
3. Install the stand.
4. Follow the procedure in
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
cable cover
4. Remove the
back
cover.
26
Removing and installing components
(optional).
After working inside your
Before working inside your
(optional).
computer.
computer.