Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
NOTE:
Repeat step 1 and 2 if there are two memory modules.
3. Align the tabs on the DIMM door with the slots on the system-board shield and snap it into place.
NOTE:
Repeat step 1 and 2 if there are two memory modules.
Next steps
1. Install the
back cover
2. Install the
cable cover
3. Install the stand.
4. Follow the procedure in
System-board shield
Removing the system-board shield
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
cable cover
4. Remove the
back
cover.
28
Removing and installing components
(optional).
After working inside your
Before working inside your
(optional).
computer.
computer.