Steps
1. Align the screw holes on the speakers with the screw holes on the display-assembly base.
2. Replace the four screws (M3 4+7.1xZN) to secure the speakers to the display-assembly base.
3. Route the speaker cable through the routing guide on display-assembly base and connect the speaker cable to the system
board.
Next steps
1. Install the
rear-I/O
bracket.
2. Install the
bottom
cover.
3. Install the
system-board
4. Install the
back cover
5. Install the
cable cover
6. Install the stand.
7. Follow the procedure in
shield.
(optional).
After working inside your
computer.
Removing and installing components
59