Led Indications In The Receiver - Salus RT510RF Full User Manual

3.2 LED indications in the receiver

The status of the RXRT510 receiver is indicated by two LEDs. These are
LEDs with the following colors:
1
- red (upper one),
2
- green (lower one).
A detailed explanation of the meaning of the LEDs can be found in the table below:
The red LED lights up
The red LED flashes
The red diode is off
The green diode lights up
The green diode is off
8
The receiver is connected to the 230V power supply and is paired with the thermostat.
The receiver can be thermostat-enabled if it is in automatic mode when the lower switch is in the AUTO position.
The receiver can be started manually when the lower switch is in the MANUAL position.
The receiver is in the pairing mode and is looking for a signal from the thermostat (then you must activate the
"PAIRING" option in the thermostat)
(or)
The receiver was paired but lost communication with the thermostat due to out of range or low battery in the
thermostat. The receiver starts flashing after one hour of time when it does not receive a signal from the thermostat.
The receiver is disconnected from the 230V power supply or the upper switch is in the OFF position.
In automatic mode, the receiver received a heating signal from the thermostat.
The receiver was started in manual mode (upper ON switch, lower MANUAL switch)
The receiver does not send a heating signal.
1
2
DESCRIPTION