Faq - LifeSpan LFTM-VFOLD User Manual

X. FAQ
Q1: Why is it showing SAFE?
The emergency stop switch is not connected.
Q2: Why the running mode will not start?
Check that the power supply of the treadmill is connected, the switch is turned on, and the
emergency stop siwtch is plugged in. Also, check that the locking devices on both sides of the
handrail have been tightened and the treadmill is showing RUN. Otherwise, the running mode will
not work due to the safety setting.
Q3: Why can't I use the Automatic mode?
Automatic mode can be used for Walking mode only. Please try to put the handrail down and then
enable automatic mode.
Q4: Why is the maximum speed is only 3km/h?
The maximum speed is 3km/h when you are using the walking mode for the first time. The maximum
speed will increase to 6km/h (3,7mi/h) after you accessed the novice guide on the App. You may also
unlock the speed limit by walking or running on the treadmill for 1km.
Q5: Why the remote is not working?
Check that the remote control has a battery and try to pair it again. Restart the treadmill and press
and hold the Mode button in the remote control AT THE SAME TIME for 5 seconds. A beep will
indicate a successful pairing. NOTE: During the pairing, the remote control should be close to the
LED display on the treadmill. (See 04. Learn to Use the Treadmill).
Q6: How to adjust belt to center before use?
Simultaneously press and hold both Mode Button and Speed Increase Button on the remote control
for over 3 seconds until device start.
Front panel will show "CALI" and keep running with speed 3km/h (2mi/h).
Walking belt goes to the left: Turn the left adjusting hole screw clockwise by 1/4 turn.
Walking belt goes to the right: turn the right adjusting hole screw clockwise by 1/4 turn.
Walking belt is slipping: Turn the left and right adjusting screws clockwise for 1/2 turn at the
same time.
After each adjustment, the treadmill needs to run for 1-2 minutes to verify the adjustments.
Please adjust again if necessary.
Press the function key to stop treadmill.
CAUTION: DO NOT OVERTIGHTEN THE BELT. PLEASE MAINTAIN ORIGINAL FACTORY BELT TENSION.
EXCESSIVE BELT TENSION WILL CAUSE DAMAGE TO MOTOR.
22

| FAQ