Table of Contents
Advertisement
6. REMOTE CONTROL PAIRING INSTRUCTIONS
If the remote control does not respond or you have replaced the remote control, you need to pair it again.
Pairing method: Restart the treadmill and press and hold the Mode button on the remote control AT THE
SAME TIME for 5 seconds.
7. CONNECTION CAUTION LIGHT
Not connected to APP: Will flicker
Connected to APP: Off
8. FAULT CAUTION LIGHT
E01: Software overcurrent
E02: Hardware overcurrent
E03: IPM Module Overheating
E04: Low-voltage Protection
E05: High-voltage Protection
E06: Motor phase loss protection
E07: Motor block rotation protection
14
| LEARN TO USE THE TREADMILL
E08: Sensor fault
E09: Motor unable to start
E12: Motor overcurrent protection
E13: Overloading protection
E14: Hall signal loss
E15: Communication fault
Hide quick links:
Advertisement
Table of Contents
