I/O; Diagnostics - ABB ACS-AP-I User Manual

50 Functions in the main Menu
Sub-menu Function
Motor Adjust motor-related settings, such as control mode, nominal values, ID run or thermal
protection. Note that the settings that are visible depend on other selections, for example
vector or scalar control mode, used motor type or selected start mode.
Loop controller Set up loop controller settings and actual values. Loop controller is only used in remote
control.
Pump and fan control Controls one motor connected to the drive and up to 3 auxiliary motors.
Communication Use the drive with a fieldbus.
Start, stop, reference Set up start/stop commands, reference, and related features, such as constant speeds
or run permissions.
Ramps Set up acceleration and deceleration settings.
Limits Set the allowed operating range. This function is intended to protect the motor, connected
hardware and mechanics. The drive stays within these limits, no matter what reference
value it gets.
PID Set up the settings and actual values for the process PID controller. PID is only used in
remote control.
Fieldbus To make the protocol configurations easier.
Advanced op- Contains settings for advanced functions, such as triggering or resetting faults through
tions/functions I/O, or switching between entire set of settings.
Clock, region, display Contains settings for language, date and time, display (such as brightness) and settings
for changing how information is displayed on screen.
Reset to defaults Enables you to reset the Home view to its original factory state.

I/O

In the I/O menu, each row provides terminal name, number, electrical status and logical
meaning of the drive. Each row also provides a sub-menu that provides further information
on the menu item and allow you to make changes to the I/O connections.

Diagnostics

The Diagnostics menu provides diagnostic information, such as faults and warnings and
helps you to resolve potential problems. Use the menu to make sure that the drive setup is
functioning correctly.
Note: The contents displayed may vary based on the drive/device to which the panel is
connected, and the menu shown is only an example.