Ic: 20555-Apwseries; Markings; Disclaimers; Generic Disclaimer - ABB ACS-AP-I User Manual

Note: The wireless panels are tested and found to comply with the limits of a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the panels are operated in a commercial
environment.
Note: The wireless panels will generate, use, and radiate radio frequency energy. If the
panels are not installed and used in accordance with the instruction manual, it may cause
harmful interference to radio communications. Operation of these panels in a residential
area is likely to cause harmful interference in which the user is required to correct the
interference at his own expense.
Note: Modifications not expressly approved by ABB Oy could void the user's authority to
operate the wireless panels.

IC: 20555-APWSERIES

￭
The ACS-AP-W and ACH-AP-W wireless assistant control panels comply with RSS- 247,
Issue 1, 2015-05. The operation is subject to the following two conditions:
1. The device may not cause interference, and
2. The device must accept any interference, including interference that may cause
undesired operation of the device.

Markings

These markings are attached to the panels:
• ACS-AP-W and ACH-AP-W
CE mark
Product complies with the applicable European Union legislation. For fulfilling the requirements
of Radio Equipment Directive (RED), see the additional information concerning the panel EMC
and RF compliance:
• IEC/EN 62368-1:2014 + A11:2017
• EN 62311:2008
• ETSI EN 301 489-1
• ETSI EN 301 489-17
• IEC/EN 61000-6-2:2019
• ETSI EN 300 328
• ACS-AP-... and ACH-AP-...
WEEE mark
At the end of life the product should enter the recycling system at an appropriate collection
point and not placed in the normal waste stream.

Disclaimers

Generic disclaimer

￭
The manufacturer shall have no obligation hereunder with respect to any product which (i)
has been improperly repaired or altered; (ii) has been subjected to misuse, negligence or
accident; (iii) has been used in a manner contrary to the Manufacturer"s instructions; or (iv)
Technical data 79