Advertisement
• If your shed was purchased with a floor, see floor kit hardware bag for assembly instructions.
• See the FLOOR LEVELING section on page 7 for recommended methods and suggested materials to properly level your floor,
as this will vary depending on your specific site.
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT! Depending on your specific use, you may want to construct a heavy duty floor frame by adding additional floor joists
(shown below as shaded). Below is a list of additional materials (not included).
x3
2 x 4 x 8' (5,1 x 10,2 x 243,8 cm) Treated Lumber
Cut lumber to 2 x 4 x 93" (5,1 x 10,2 x 236,2 cm)
Treated Lumber
x12
ea. 3" (7,6 cm) hot-dipped galvanized nails
3-TAB SHINGLES ...........................................6 Bundles
PAINT FOR SIDING ........................................2 Gallons
Use 100% acrylic latex exterior paint. (2) coats recommended.
CAULK ............................................................3 Tubes
Use acrylic latex exterior caulk that is paintable.
DRIP EDGE ...................................... 50 Feet
TO VALIDATE YOUR WARRANTY YOU MUST USE THE FOLLOWING:
CAULK .............................................. 1 Tube
For windows use acrylic latex exterior caulk that is paintable.
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER'S INSTRUCTIONS FOR
ADDITIONAL MATERIALS
FOUNDATION OR FLOOR MATERIALS
COMPLETING YOUR SHED
You will need these additional materials:
INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
1" GALVANIZED ROOFING NAILS.... 3 Lbs
For shingles.
PAINT FOR TRIM ............................... 1 Quart
Use 100% acrylic latex exterior paint.
1" GALVANIZED ROOFING NAILS... 1/4 Lb
For roofing felt.
#15 ROOFING FELT
To cover 159 Sq. Ft. of roof area.
3
Optional 12" (30,5 cm) spacing
Advertisement
