Advertisement
PARTS REQUIRED:
x1
13-7/8 x 48"
(35,2 x 121,9 cm)
3
Install a 13-7/8" x 48" roof panel flush to the
installed panel and flush at peak (Fig. B).
Secure panel with (2) 2" nails in the corners.
4
Move the gable until it is at 1/2" (Fig. C)
from the 13-7/8" x 48" roof panel.
Finish securing panel with (2) 2" nails in
the corners.
5
Maintain spacing between the center of the rafters
at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter.
Move to the top of the panel and keep spacing
between the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
24-3/8"
(61,9 cm)
ROOF PANELS
NOTE:
Measurements are to outside of rafter.
24"
24"
(61 cm)
(61 cm)
Two Nails
Fig. D
24"
(61 cm)
2" (5,1 cm)
Nails
43
x12
2" (5,1 cm)
Flush
Fig. C
24-3/8"
24"
(61,9 cm)
(61 cm)
Flush at
peak
Fig. B
1/2"
(1,2 cm)
Gable
End Rafter
Advertisement
