It's Easy . . . It's Handy
Loft Parts List
❑ 4
Loft Beams, Pre-assembled halves 3x5-1/2" Beam Half
❑ 2
Short Rear Loft Supports
❑ 1
Long Rear Loft Support
❑ 25 Loft Boards
❑ 1
Loft Trim Angled
❑ 1
Loft Trim Angled
❑ 4
Metal Angle Brackets
❑ 8
3/8" x 2" Lag Bolts with Nuts and Washers
❑ 8
1/4" x 2" Lag Screws
❑ --
3" Screws, 2" Screws
Tools Required
❑ 1/8" Drill Bit, 3/8" Drill Bit, Phillips #2 Bit
❑ Drill
❑ Adjustable or 7/16" and 9/16" Wrench
The loft is supported by a 2x4 attached to the rear wall and (2)
3x5-1/2x140" beams in the middle and front of the loft.
1-A: Position short 2x4x25" flush to edge of side wall and flush to the
top of the rear wall, attach with 3" screws every 16" and continue
across the back wall with 2x4x90" flush to top and last 2x4x25" in
other corner.
Note: If Optional Wall Partition is used, only (1) 3" x 5-1/2"
beam is required in the middle of the loft at the 93" dimen-
sion. See partition instructions for details.
1-B: Assemble the 3 x 5-1/2" loft half beams as shown using wood
glue [not supplied] and (10) 3" screws at slight angle for middle Loft
Support and repeat step for another Beam support for front of Loft.
Total assembled length will be 140"
1-C: Position metal angle brackets on the side wall centered at
43" and 87-1/2" from the back wall on both sides of building.
Measurements are from the inside of building and centered on
the bracket.
1-D: Attach metal angle bracket 5-1/2" down from the top of the side
wall, mark holes and drill 3/8" diameter hole through side wall panel.
Fasten bracket to wall with (2) 3/8 x 2" bolts with (2) washers and lock
nuts to the outside of building as shown.
Mackinaw Loft
2x4x25"
2x4x90"
1x6x90"
1x3x50"
1x3x90"
#15649
1A
3" Screws
every 16"
2x4x25"
1B
Completed beam with (10) 3" screws
Measure from inside building
1C
Rear of
Building
1D
Washer
and Nut
3/8" Dia
Hole
Revision: 03-19-07
Run:
2x4 attached to top
of Rear Wall
2x4x90"
2x4x25"
Apply wood Glue
140"
87-1/2"
43"
Side Wall
Top of Side Wall
5-1/2"
Bolt
Inside
Side
Wall