Advertisement
Installation
A. Prepare frame and door.
1.
Using templates supplied with double swing hinge
and emergency release stop products, prepare door
and frame. (Figure 1)
NOTE: These instructions illustrate the Markar
DSH1000 hinge and the Pemko DSHP01
hinge with Pemko ERS or ERSMP stop. For
comprehensive information about those
products, please visit assaabloydooraccessories.
us. For other manufacturers' hinge and/or stop
products, please consult Rixson Support for
templating and installation modifications.
2.
Using template provided with these instructions,
prepare frame header and door for closer. (Figure 2)
3.
Confirm all cutout dimensions for closer.
NOTE: Closer is installed centered to closed door.
Depending on application, it may not be centered
in width of frame header.
B. Install hinge and emergency release stop.
1.
Verify frame is square and plumb.
2.
Using manufactures' installation instructions, mount
hinge and frame stop supplied by others.
3.
Mount door to leave 3/32" (2) gap between top of
door and frame header. (Figure 3)
NOTE: Door should swing freely.
C. Assemble track.
1.
Slide track components into track.
(Figure 4)
NOTE:
• All track components must be placed in track
before installing track into door.
• Insert slider into track first.
• Stop block (or optional hold open) should be
last component at hinge side of door.
• The longer end of slider should be pointed
towards hinge side of door.
4
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2021-10-20
Model 73ER, Metal Frame
Markar DHS1000
Double Swing Hinge
Figure 1
Metal Frame
Figure 2
Non Hold Open Track Components
Slider
Optional Hold Open Track Components
Slider
Figure 4
Pemko Emergency
Release Stop
Top of Door
3/32
(2)
Figure 3
IS73ER Rev 1 10/21
Advertisement
