Rim Exit Installation Instructions; Verify Hand And Bevel Of Door; Prep Door According To Door Marker Fm429; Install Door Position Switch (Dps) - Assa Abloy Corbin Russwin ED5200SN Series Installation Instructions Manual

ED5200(S)N & ED5600N Series with Aperio™ Technology
Exit Devices - Includes Rim and Mortise
Installation Instructions
6

Rim Exit Installation Instructions

a

Verify Hand and Bevel of Door

1. Door should be fitted and hung.
2. Verify box label for size of exit device, function, and hand.
b

Prep Door According to Door Marker FM429

• For door manufacturer templates visit www.corbinrusswin.com
and reference template #'s T31235 & T31236.
c

Install Door Position Switch (DPS)

1. Insert DPS into raceway on latch edge of door.
2. Push wires through raceway toward lock prep.
3. Push DPS firmly into place by hand.
Note: Do Not Tap Switch With Any Tool.
4. Install magnet into door frame. Push firmly into
place by hand. See instruction A7983A.
If DPS is not installed or is installed improperly, door
status monitoring features will not function.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited.
Left Hand
Reverse LHR
Outside
of Door
Raceway for
Auxiliary Hard-
power
Through-bolt
Holes
Figure 4
Inside
Outside
Figure 2
Wood Door Preparation
Door Position
Switch (DPS)
Raceway
Backplate
Mount
Holes
Figure 3
8
Right Hand
Reverse RHR
Inside
of Door
Raceway
for Auxiliary
Hard-power
Through-
bolt
Holes
Trim
Tailpiece
Hole
Through-
bolt
Holes
FM431 12/22