Mitsubishi Electric Melsec Q Series User Manual page 93

7 Setting and procedure for operation
7.6.4 Auto Refresh
This function transfers data in the buffer memory to specified devices.
Programming of reading/writing data is unnecessary.
(1)Setting procedure
1) Start "Auto Refresh" .
2) Start "Auto Refresh" .
Click the item to set, and input the destination device for auto refresh.
Point
Project window→[Intelligent Function Module]→Module name→[Auto Refresh]
Available devices are X, Y, M, L, B, T, C, ST, D, W, R, and ZR.
When a bit device X, Y, M, L, or B is used, set a number that is
divisible by 16 points (example: X10, Y120, M16).
Data in the buffer memory are stored in 16 points of devices
starting from the set device No. (Example: When X10 is set, the
data are stored in X10 to X1F).
7 - 21
QE81WH