Table of Contents
Advertisement
5.0 Operation
STATUS
LS VDC
•
Load Support VDC – The inverter/charger is in Load Support (Volts
DC) mode because an external DC source (solar, wind, etc.,) is providing
more current than needed—which causes the battery voltage to rise. The
inverter/charger reduces the incoming AC current in an effort to keep the
battery voltage from rising above the temperature-compensated Bat t ery
Type setting.
Info: The Load Support VDC feature operates in parallel with the
AC input to support the inverter loads and is only available on MSH
Series inverter/chargers. This feature is only active in the Absorb
or Float Charge modes and when the inverter is enabled (INV LED
is on); it is deactivated if the charger is in Charger Standby.
STATUS
Mode XX
•
Unknown Mode XX – The remote doesn't recognize the mode the
inverter is reporting. Contact Magnum Technical Support (425-353-8833)
for assistance.
29
LS VDC appears on the LCD. The FAULT
(red) LED is off, and the INV (green)
LED is on.
Figu r e 5 - 1 4 , Loa d Su ppor t VD C
Mode XX appears on the LCD. The
FAULT (red) LED is off, and the INV
(green) LED could be on or off.
Note: XXs are j ust placeholders for
t he act ual charact ers t hat appear.
Figu r e 5 - 1 5 , Un k n ow n M ode
© 2020 Sensata Technologies
Advertisement
Table of Contents
Troubleshooting
