Installation; Tank Filling; Power Grid Connection; Coffee Spout - FlyTek MAXIBAR Operation And Maintenance Manual

Remove the machine from the packaging and place it on a stable, horizontal surface, suitable to support
its weight, near a suitable power socket. The coffee machine must be installed in an environment with a
minimum temperature of 15°C and a maximum temperature of 25°C. Keep the original packaging in all its
parts for possible future transport.
Remove the cup warmer (ref. G) to access the water tank. WE RECOMMEND USING A SOFTENER AND
ANTI- SCALE FILTER that needs to be periodically replaced. Should this not be done, scale deposits may
form inside the machine that could jeopardize its proper functioning and the validity of the warranty. After
having inserted the softener filter inside the tank, fill it with drinking water with low calcium content. We
recommend filling the tank using a funnel and a bottle.
The machine is equipped with a water tank level sensor. If the water in the tank reaches a level that is too
low, any ongoing coffee dispensing will be interrupted and the three LED lights on the control panel (ref.
D) will start to flash at the same time, indicating that the tank needs to be filled as explained above. To
avoid reaching this point, we recommend you to periodically check the water level.
If water freezes inside the machine system, disconnect the power plug, switch off the machine and
place it in a heated room with a temperature of at least 15°C. Wait about 30 minutes before switching
the machine on and using it again. To prevent the machine from freezing and for an optimal general
performance, we recommend using it in an environment with a temperature not below 15°C.
If the external power cable of this device is damaged, it must be replaced by a special cable provided by
the Manufacturer or by the Customer Service.
The coffee spout is located on the front side of the machine.

POWER GRID CONNECTION

The supply voltage of the machine cannot be modified by the user. Before
connecting the device to the power grid, check that the mains voltage
corresponds to the machine's supply voltage indicated on the identification plate.
COFFEE SPOUT (ref. B)
While the machine is dispensing coffee, do not touch the spouts and do not
expose your face to the hot parts of the machine (danger of burns). The heating
surfaces of the machine are subject to residual heat even after use!

INSTALLATION

TANK FILLING

16