Power On; How To Make Coffee - FlyTek MAXIBAR Operation And Maintenance Manual

Turn on the machine by pressing the general power switch (ref. K) located at the bottom on the front side of
the machine. Set the switch to position 1 to activate the coffee brewing unit and the cup warmer. In order to
also use the boiler for steam and hot water production, set the switch to position 2.
Turn the general power switch (ref. K) in position 1 or 2 and wait about two minutes for the coffee group to
reach optimum operating temperature and thus be ready for use.
Once this time has elapsed, operate the pod-press lever (ref. F) lifting it upwards. Insert a pod into the
pod holder and gently lower the lever until it clicks into place. Place a cup under the coffee spout (ref. B)
and press one of the three keys (short coffee, long coffee or manual start/stop) on the corresponding
control panel (ref. D). For example, if you want to prepare a short coffee, you have to press key 0 on the
control panel:
If instead you want to make a long coffee, you have to press key 1 on the control panel. Once you have
pressed one of the coffee dispensing keys, you have to wait about three seconds until the coffee starts
to flow out. Once the programmed dose has been reached, the coffee dispensing stops automatically
(except when you press key 2). If you want to stop the delivery earlier, simply press the same key again.
Once the coffee has been dispensed, we recommend removing the pod to prevent it from sticking as it
dries.
It is important to empty the drip tray (ref. A) after dispensing not more than 50 cups of coffee.

HOW TO MAKE COFFEE

0
Please remember to use only pods provided by your Supplier. The use of
different pods from those for which the coffee machine was designed may not
guarantee the same dispensing quality.
If the tray is not emptied, water may leak out.

POWER ON

1 2
17