Coffee Group And Steam Wand Cleaning; Machine Cleaning; Common Problems And Possible Solutions - FlyTek MAXIBAR Operation And Maintenance Manual

The coffee group must be cleaned weekly. To clean it, you have to make a coffee without a pod. Lower the
pod-press lever (ref. F), place a sufficiently large cup under the coffee spout (ref. B) and press the long
coffee key (1); after about three seconds, hot water will start to flow out. Once the programmed dose has
been reached, the water dispensing will stop automatically.
The steam wand must be cleaned daily if used. To do this, place the steam wand (ref. M) inside a cup or
other recipient containing only clean water and turn the steam knob (ref. I) anticlockwise until the
maximum steam output is reached. After one minute, turn the same knob clockwise again until the steam
output stops completely. Wait until the steam wand has cooled sufficiently, then clean its outer surface
with a soft cloth dampened with hot water. Remove all deposits (e.g. milk) to prevent obstruction of the
steam outlet holes.
Any type of cleaning, except that of the brewing unit, must be carried out when the machine is turned off
(general power switch on zero) and after it has cooled down. To clean the external surface of the machine,
use a soft wet cloth. The drip tray (ref. A) must be removed and washed with hot water and soap using a
non-abrasive sponge and must be thoroughly dried before being reinserted.
Repairs must be exclusively executed by authorized and qualified personnel. If you are unable to solve the
problems with the help of the following table, please contact your Authorized Retailer.

COFFEE GROUP AND STEAM WAND CLEANING

MACHINE CLEANING

Do not use the dishwasher to clean the machine or its components. They would
be irreparably damaged! Do not use solvents and abrasive products or materials.
If you clean the tank with detergents, be sure to rinse it thoroughly, as any
chemical residues inside the tank may cause food poisoning.

COMMON PROBLEMS AND POSSIBLE SOLUTIONS

Any repairs executed without observing the manufacturing specifications and/or
using non-original spare parts may be a source of danger to the user. If the water
in the tank runs out, the pumps may burn and consequently the machine may
short-circuit.
19