Page 2
Record the following purchase information for your records or in the event you need to contact DreamLine ® Purchase Order Store/Vendor Number Purchased From OD Number Installation Date (optional) located on the shipping box or label if available. SKU Number...
Table of Contents Section Title Page # Warnings and General Preparation Model Specific Preparation Adjustable Wall Profile System Tools Detailed Diagram of Aqua-Q Swing Shower Door Components Parts List Installation Steps 8-15 Aluminum Threshold Dam Strip Installation Vinyl Seals Installation Handle/Towel Bar Installation Product Maintenance Troubleshooting...
Page 4
IMPORTANT GENERAL PREPARATION • DreamLine® reserves the right to alter, modify or redesign products any time without • After opening all boxes and packages, read this introduction carefully. Check that all the prior notice for product improvement and customer experience. Please refer to the items are included in the package by marking off the components on the “Detailed...
Model Specific Preparation REQUIRED: ±0.0 ±0.0 1-1/2” minimum threshold 1/2” (12mm) maximum Out-of-Plumb Adjustment within the Wall Profile; Verify threshold and walls with a level 1-1/2“ (37.5mm) minimum threshold ±0.0 Threshold must be level Contact the manufacturer of the base, tub or NOTE threshold material with any questions regarding Tile...
Adjustable Wall Profile System Wall Profile Glass The Glass Profiles can be adjusted up to Profile 1/2” within the Wall Profile for overall width or to correct for out-of-plumb conditions within the model size. Screw them together after making final adjustments.
Before discarding the carton, check for small hardware bags that may have fallen to the bottom of the box. If any NOTE parts are damaged or missing, please contact DreamLine for replacement. The shipping ®...
Installation Steps Check the walls for plumb and threshold for level. This model allows NOTE for up to 1/2” of out-of-plumb adjustment within the Wall Profile. The threshold must be level for correct installation. Fig 1 Confirm the Wall Profile (#01) is Tools Needed Parts Needed plumb with a level before marking...
Page 11
*see NOTE *see NOTE silicone the back of the Wall Profile Install the Wall Profiles (#01) Fig 2 NOTE so that the holes face the inside of the shower. ◾If a Stud is present behind the wall: NOTE drill a Ø3/16”(4mm) hole up to the stud, drill an Ø1/8”...
Page 12
Before installing the Door Glass (with pre-installed Glass Profile), make sure the NOTE side with the ID Groove, screw holes and ID Groove Vinyl Seal are facing the inside of the shower. Screw Hole Vinyl Seal Inside of Shower Fig 3 Parts Needed Place 1/2”...
Page 13
Optional Step This optional step requires drilling into the threshold, which may have warranty implications in the case of some prefabricated shower pans. If in doubt, check the shower pan manufacturer’s warranty. If additional stability is desired for the Bottom Pivot Bracket, it can be screwed NOTE to the threshold.
Page 14
Decorative Caps Installation Make sure the Door Glass is plumb and level. Drill Ø1/8” holes through the pre-drilled holes in the Wall Profile (#01). Drill only through the first layer of NOTE the Glass Profile and install the ST4.0x10mm Pan Head Screws (#05) using the Decorative Cover and Washer (#06) Do not overtighten screws.
Page 15
Threshold Installation Open the Door Glass and install the Threshold Dam Strip. NOTE inside inside Fig 5 This product is shipped with both a left and right Dam Strip Clip installation. The large curved lip of the dam strip is intended to face toward the outside of the shower NOTE to ensure the flow of water is redirected towards the drain.
Handle/Towel Bar Installation Be sure to use all the gaskets correctly to prevent any metals to glass contact. inside outside Parts Needed Fig 7 AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
Page 18
The surfaces need to be clean and free of debris before applying silicone NOTE Fig 8 Allow 24 hours for the silicone to cure before using the shower Tools Needed AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
To maximize the life of your door, it is important to regularly inspect the glass and other hardware for misalignment, proper attachment, NOTE and/or damage. Contact DreamLine with any questions or concerns. ® AQUA Maintenance Checklist ◻...
Page(s) • Check all shipping/packaging material for missing parts/components. Missing Parts • If not found, contact DreamLine Customer Support [1-866-731-2244] to order factory part replacement. • Check the Vinyl Seal for proper installation • Confirm the Decorative Cover and Washer is tightly secured to the...
04 = Brushed Nickel 06 = Oil Rubbed Bronze 09 = Satin Black Contact Support@DreamLine.com for Part replacement, installation assistance or additional information. Complete Warranty information is available on DreamLine.com. AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
Page 22
04 = Brushed Nickel 06 = Oil Rubbed Bronze 09 = Satin Black Contact Support@DreamLine.com for Part replacement, installation assistance or additional information. Complete Warranty information is available on DreamLine.com. AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
Page 23
04 = Brushed Nickel 06 = Oil Rubbed Bronze 09 = Satin Black Contact Support@DreamLine.com for Part replacement, installation assistance or additional information. Complete Warranty information is available on DreamLine.com. AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
Page 24
NOTES: AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
Page 25
TEL: 866-731-2244 FAX: 866-857-3638 DREAMLINE.COM For more information on DreamLine Shower Doors and Enclosures please visit DreamLine.com ® AQUA-Q SWING Shower and Tub Door Manual Ver 1a 052021...
Need help?
Do you have a question about the AQUA-Q SWING SD-373472Q Series and is the answer not in the manual?
Questions and answers